LM datasheet, LM pdf, LM data sheet, datasheet, data sheet, pdf, National Semiconductor, 80V Triple Bias Clamp. Part Number: LM, Maunfacturer: National Semiconductor, Part Family: LM, File type: PDF, Document: Datasheet – semiconductor. The LM driver is an Integrated 80V triple bias clamp cir- . Note: Information contained in this data sheet is preliminary and may be subject.
|Published (Last):||25 June 2011|
|PDF File Size:||3.19 Mb|
|ePub File Size:||19.67 Mb|
|Price:||Free* [*Free Regsitration Required]|
The guaranteed specifications apply only for the test conditions listed. Absolute Maximum Ratings indicate limits beyond which damage to the device may occur.
LM datasheet, Pinout ,application circuits 80V Triple Bias Clamp
A critical component is any component of a life support device or system whose failure to perform can be reasonably expected to cause datasyeet failure of the life support device or system, or to affect its safety or effectiveness.
F capacitor should be connected from the supply pin, Vcc, to ground, as close to the supply and ground pins as is practical.
No additional components are required to protect the LM from arc damage. Information contained in this data sheet is preliminary and may be subject to change without notice.
LM Datasheet pdf – 80V Triple Bias Clamp – National Semiconductor
Each amplifier has its gain internally set to Figure 2 shows the test circuit used for evaluation of the LM Clamp Amplifier. Simplified Schematic One Channel? National Semiconductor Corporation Americas Email: For guaranteed specifications and the test conditions, see the Electrical Characteristics. The output requires datashert resistor to 80V.
It shows all the components necessary to optimize performance as lm22480 as to protect against damage from a CRT arc event. Life support devices or systems are devices or systems which, a are intended for surgical implant into the body, or b support or sustain life, and whose failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in a significant injury to the user.
The DC clamp circuit amplifies the input signal datasheef and the gain is set by the resistor ratio of 18R and R.
All voltages are measured with respect to GND, unless otherwise specified. Some performance characteristics may change when the device is not operated under the listed test conditions.
The DC transfer function is shown in Figure 4. Capacitor C4 stabilizes the entire node at the anode of the clamp diode, D3, by creating a low impedance at high frequencies. Application Circuit The application circuit shown in Figure 5 is designed to help clamp the voltage at the output of the driver to the desired level.
To obtain demonstration boards contact the National Semiconductor Sales Office in your region. Operating Ratings indicate conditions for which the device is functional, but do not guarantee specific performance limits.